2006 Lincoln Zephyr Key Fob Programming Instructions

This keyless remote programming instructions work for new 4B cars remote with part # 8S4Z-15K601-A, 8S4T-15K601-AA, 2S4T-15K601-AB, 2S4Z-15K601-AA, FCC id CWTWB1U345, CWTWB1U331 on the back of it.

Replacement Remote 8S4Z-15K601-A, 8S4T-15K601-AA, 2S4T-15K601-AB, 2S4Z-15K601-AA,  CWTWB1U345, CWTWB1U331
Replacement Remote
Attention: Existing remotes may be deleted from the system’s memory once a new remote has been programmed. So, make sure to reprogram them if you wish to use them as well.

1. Insert the keys in the ignition then twist it OFF to RUN 8 times within 10 seconds, ending in OFF position (this is to put the system in programming mode for your new remote). You will know your system has entered the programming mode once the door locks cycled (lock then unlock).

(Note: The RUN position is as far as you can turn the key  without cranking the engine. If the door locks do not cycle indicating programming mode has been entered, try the procedure without doing step 1 and having the driver door closed. If you still can’t get into programming mode after trying this numerous times both ways then you either do not have the factory keyless entry system or it is not functioning properly. In many vehicles you should end in the RUN position and not the OFF position. If you have anti-theft deterrent then before doing
this step you should open the driver door and cycle the power door locks twice. This means you press LOCK, UNLOCK, LOCK, UNLOCK. Step ones says to turn from OFF to RUN up to eight times. If the locks cycle before eight times then move onto step 2 immediately. Do not continue cycling the ignition switch.)
2. Within 15 seconds, press any button on the remote. Door locks will cycle if the remote has been successfully programmed.
3. To program another remote just go back to step 2.
4. If the door locks did not cycle, wait 10 seconds and press any button again.
5. To exit the system from programming mode just turn the key in the ignition to OFF position or wait up to 30 seconds after step 2.

Leave a Reply

Your email address will not be published. Required fields are marked *