2005 Subaru Legacy Key Fob Programming Instructions

This keyless remote programming instructions work for SUBARU remote with part # 88036-AE060, 88035-AC231, 88036-XA010, FCC id A269ZUA111 on the back of it.

Replacement Remote 88036-AE060, 88035-AC231, 88036-XA010, A269ZUA111
Replacement Remote
1. Open the remote, locate and write down the eight digit number on the circuit board.
2. Sit in driver seat, close all doors and trunk.
3. Open and close the driver door one time.

Perform these steps in 45 seconds:
4. Open and close the driver door once.
5. Put the key in the ignition and turn it from LOCK to ON 10 times within 15 seconds. You’ll hear a tone once and buzzer. The interior light will flash until the remotes are programmed.
6. Within 15 seconds open the driver door then close it. You’ll hear a tone 30 seconds.

7. Before the tone stops press the power door lock button to LOCK the same number of times as the first digit of the circuit board code. Press UNLOCK to indicate you are moving to the next digit. Repeat this step for each digit. After each digit entry press UNLOCK within 5 seconds or the process will time out.
8. After putting all 8 digits, within 5 seconds press UNLOCK and repeat step 6 all over again. After the 8th digit a tone will sound for 30 seconds.

9. To add additional remotes repeat steps 5 to 8 for each remote.
10. When you are finished remove key from ignition.

Leave a Reply

Your email address will not be published. Required fields are marked *