2005 Subaru B9 Tribeca Key Fob Programming Instructions

This keyless remote programming instructions work for L,U,T, P(Square in half circle) remote with part # 88036-XA010 FCC id NHVWB1U711 on the back of it.

Replacement Remote 88036-XA010, NHVWB1U711
Replacement Remote

1. Open the remote, look for the 8 digit number on the circuit board and take note of it.
2. Sit in driver seat, close all doors and trunk.
3. Open the driver door then close it again. Perform these steps in 45 seconds:

4. Open and close the driver door once.
5. Put the key in the ignition and turn it from LOCK to ON 10 times within 15 seconds. You’ll hear a tone once and buzzer. The interior light will flash until the remotes are programmed.
6. Within 15 seconds open the driver door then close it. You’ll hear a tone 30 seconds.
7. Before the tone stops press the power door lock button to LOCK the same number of times as the first digit of the circuit board code. Press UNLOCK to indicate you are moving to the next digit. Repeat this step for each digit. After each digit entry press UNLOCK within 5 seconds or the process will time out.
8. After putting all 8 digits, within 5 seconds press UNLOCK and repeat step 6 all over again. After the 8th digit a tone will sound for 30 seconds.
9. To program another remote just repeat steps 5 to 8 for each remote.
10. Remove the key from the ignition once you’re done as the system will exit programming mode.

Leave a Reply

Your email address will not be published. Required fields are marked *