2005 GMC Envoy XUV Key Fob Programming Instructions

This keyless remote programming instructions work for Envoy XUV remote with part # 15135557 NEW 15772899 #1 15772901 15772900 #2 15135559 #2 FCC id MYT3X6898B and part #  on the back of it.

Replacement Remote 15135557, 15772899, 15772901, 15772900, 15135559, MYT3X6898B
Replacement Remote
NOTE: Once your system is in programming mode it will automatically delete all saved remote’s code from it’s memory. Make sure to reprogram your existing remote after programming the new one.

1. Close all the doors and windows, wait for the dome light to go OFF.
2. Put the key in the ignition.
3. Press and hold the power UNLOCK button on the driver’s door panel until you’re instructed to release it in step 9.
4. Perform steps 5 through 8 in fairly rapid succession.
5. Turn the key in the ignition to ON position (don’t start the engine).
6. Twist the key in the ignition back to OFF position.
7. Turn the ignition switch to ON position.
8. Turn the ignition switch back to the OFF position.
9. Release the power unlock button on the door panel. The door locks cycle (lock and unlock)
10. Press and hold LOCK and UNLOCK on the remote at the same time until the door locks cycle. Wait up to 30 seconds.
11. To program another remote just go back to step 10.
12. Turn the key in the ignition back to ON position to turn the programming mode OFF.

Leave a Reply

Your email address will not be published. Required fields are marked *