2004 Mercury Monterey Key Fob Programming Instructions

This keyless remote programming instructions work for 3B remote with part # 8L3Z-15K601-B, 8L3Z-15K601-AA, 8L3T-15K601-AA, F8DB-15K601-AA, 2L3T-15K601-AA, 2L3T-15K601-AB, and FCC id CWTWB1U345, CWTWB1U331 on the back of it.

Replacement Remote 8L3Z-15K601-B, 8L3Z-15K601-AA, 8L3T-15K601-AA, F8DB-15K601-AA, 2L3T-15K601-AA, 2L3T-15K601-AB, CWTWB1U345, CWTWB1U331
Replacement Remote
Attention: Existing remotes may be deleted from the system’s memory once a new remote has been programmed. So, make sure to reprogram them if you wish to use them as well.

1. Insert the keys in the ignition then twist it OFF to RUN 8 times within 10 seconds, ending in OFF position (this is to put the system in programming mode for your new remote). You will know your system has entered the programming mode once the door locks cycled (lock then unlock).

(Note: The RUN position is as far as you can turn the key without cranking the engine. If the door locks do not cycle indicating programming mode has been entered, try the procedure without doing step 1 and having the driver door closed. If you still can’t get into programming mode after trying this numerous times both ways then you either do not have the factory keyless entry system or it is not functioning properly. In many vehicles you should end in the RUN position and not the OFF position. If you have anti-theft deterrent then before doing this step you should open the driver door and cycle the power door locks twice. This means you pressLOCK, UNLOCK, LOCK, UNLOCK. Step ones says to turn from OFF to RUN up to eight times. If the locks cycle before eighttimes then move onto step 2 immediately. Do not continue cycling the ignition switch.)
2. In 10 seconds, press any button on the first remote you’re programming. Door locks will cycle if the remote has been successfully programmed.
3. Repeat step 2 to program another remote including the existing/old ones.
4. If you didn’t get any indication that the remote has been programmed, wait 10 seconds and press any button again.
5. After programming the remotes ofcourse you will need to exit programming mode. To do that, you will need to twist the key in the ignition to OFF or wait up to 30 seconds for the system to turn program mode itself.

Leave a Reply

Your email address will not be published. Required fields are marked *