2004 Chrysler Voyager Key Fob Programming Instructions

This keyless remote programming instruction works on this remote with part # 04686797AA, 04686797AB, and FCC id  GQ43VT18T 

Replacement Remote 04686797AA, 04686797AB, GQ43VT18T
Replacement Remote
1. Press the LOCK button 5 times on the existing (programmed) remote with 2 second intervals to re synchronize.
2. Turn the ignition to RUN position (Don’t start the engine). Wait for chimes to stop.
3. Using the working (programmed) remote, press and hold the UNLOCK button on for between 4 and 10 seconds.
4. Within the specified 4 to 10 seconds, just keep on pressing the UNLOCK button and press the PANIC button for 1 second then release both buttons. A chime will sound to indicate that you’re now in programming mode has been entered (allow 3 seconds for chime to sound).
5. Within 30 seconds of chime, press the LOCK and UNLOCK buttons at the same time then press and release just the UNLOCK button on the SAME remote. A chime will sound indicating the remote has been re-programmed. Repeat this step (press and release the LOCK and UNLOCK buttons at the same time then press and release just the UNLOCK button) for each new transmitter you wish to program. A chime will sound after each additional remote is programmed.
6. Turn the ignition to OFF position, remove the keys to exit from programming mode.
7. Test each remotes function to make sure.

TROUBLESHOOTING: If, the door locks unlock instead of giving you a chime at the “press and release just the UNLOCK button” in the second line at step 5, then you need to reverse steps 1 and 2.

Leave a Reply

Your email address will not be published. Required fields are marked *