2003 Mitsubishi Outlander Key Fob Programming Instructions

This keyless remote programming instructions work for L,U remote with part # MR587983, FCC id OUCG8D-525M-A, and part # G8D-525M-A on the back of it.

Replacement Remote MR587983, OUCG8D-525M-A, G8D-525M-A
Replacement Remote
1. Locate the Data Line Connector (DLC) underneath the driver’s side dashboard. The DLC is typically located either to the left or the right of the steering column base. Use the figure to the side as a map for your DLC (they usually aren’t numbered). The view in figure b, is looking straight into the cavities of the DLC. Notice
how the DLC is tapered on both ends: we will be working on the wider row of cavities (1 through 8 in figure b.).
2. Insert keys in ignition and leave in the OFF position.
3. Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Line Connector (DLC) terminal 1 to terminal 4 with a suitable jumper wire (leave the jumper wire connected throughout the
programming procedure). Make sure you know which terminals are 1 and 4.

4. Within 10 seconds after connecting the jumper wire, press the Hazard Switch 6 times. The doors will automatically lock and unlock once indicating that the system is in the programming mode.
5. Press either the LOCK or UNLOCK button on the transmitter to be registered three times within 10 seconds.
Upon successful programming, the door will lock and unlock once.

6. If there is a second transmitter, press the LOCK or UNLOCK button three times within one minute and the
doors will lock and unlock once to confirm successful programming.
7. Disconnect the programming wire and remove the keys from the ignition.

1 thought on “2003 Mitsubishi Outlander Key Fob Programming Instructions”

  1. Hi – I’ve not been able to get this to work.
    I purchased a new fob and put in a new battery.
    I’ve tried the above instructions many times with no luck. I’m able to accomplish up through Step 4, but after that, when I try Step 5 nothing happens. I’ve tried it several times, with the door open, with the door closed, with the key in the OFF position, with the key in the ACC position, and with the key in the ON position, but no luck.
    Any suggestions? Thanks!

Leave a Reply

Your email address will not be published. Required fields are marked *