2003 Mitsubishi Lancer Key Fob Programming Instructions

This keyless remote programming instructions work for L,U,T remote with part # MR587980, MR558501, FCC id OUCG8D-525M-A, and part # G8D-525M-A on the back of it.

Replacement Remote MR587980, MR558501, OUCG8D-525M-A, G8D-525M-A
Replacement Remote

1. Look for the Data Line Connector (DLC) underneath the driver’s sidedashboard. DLC can be located either to the left or the right of the steering column base. The figure to the side will serve as a map for your DLC (they usually are not numbered). View in figure b, is looking straight into the cavities of the DLC. Check
how the DLC is tapered on both ends: we will be working on the wider row of cavities (1 through 8 in figure b.).
2. Put the key in the ignition leave it OFF.
3. Check if metal contact pins are present in terminals 1 and 4, then use a jumper wire to connect the terminal 1 and 4. NOTE: Make sure you know which terminals are 1 and 4 and leave the jumper wire connected until the 7th step.

4. Within 10 seconds after connecting the jumper wire, press the Hazard Switch 6 times. The doors will automatically lock and unlock once indicating that the system is in the programming mode.
5. Press either the LOCK or UNLOCK button on the transmitter to be registered three times within 10 seconds.
Upon successful programming, the door will lock and unlock once.
6. If you want to program another remote just press Lock or Unlock button 3 times within 1 minute. Door locks will cycle indicating it’s been programmed.
7. Take the jumper wire the terminals and the key from the ignition to exit from programming mode.

Leave a Reply

Your email address will not be published. Required fields are marked *