This keyless remote programming instructions work for panic is red button white icon remote with part # 0K58A-677T0, FCC id PLNBONTEC-T009 on back on the back of it.
 |
| Replacement Remote |
1. Jumper terminal 12 and 16 of the Diagnostic Connect (Check the diagram below) found in the engine compartment adjacent to the battery.
2. Put the key in the ignition then turn it to ON position (Don’t start the engine).
3. Press LOCK button on the remote twice.
4. Repeat step 3 for another remote.
3. Press LOCK button on the remote twice.
4. Repeat step 3 for another remote.
5. Turn the ignition to OFF position and take the key out.
6. Disconnect the jumper wire from diagnostic connector.
7. Test remote(s).
6. Disconnect the jumper wire from diagnostic connector.
7. Test remote(s).