2003 Dodge Viper Key Fob Programming Instructions

This keyless remote programming instructions work for  remote with part # 04602260AA, 04602260AD, and FCC id GQ43VT17T on the back of it.

Replacement Remote 04602260AA, 04602260AD, GQ43VT17T
Replacement Remote
To Program Transmitters:

This feature allows you to program transmitters in case one is lost or an extra transmitter(s) is desired. Up to 4 transmitters can be programmed to your vehicle. To program another transmitter follow these steps:

1. Turn the ignition switch to the ON/RUN position and set the parking brake.
2. Using a previously programmed transmitter, press the UNLOCK button for 5 to 10 seconds. While the UNLOCK button is being pressed (after 5 seconds). press the Panic button and release both buttons simultaneously. You will hear a chrime sound to signal you that programming on the transmitter(s) may occur.

3. You may program up to 4 transmitters for your vehicle within a 30 second time limit. Press and release both LOCK and UNLOCK buttons of a new transmitter at the same time: then press and release any of the buttons once, you will hear a chime when the transmitter has been successfully programmed. A chime will sound when the 30 seconds is over, or if you turn the ignition switch OFF.
4. You must repeat step 3 for all new transmitters that will be used with this vehicle (up to 4 total).

Leave a Reply

Your email address will not be published. Required fields are marked *