2003 Dodge Intrepid Key Fob Programming Instructions

This keyless remote programming instruction works on this 4B remote with part # 04602260AA, 04602260AD, and FCC id GQ43VT17T

Replacement Remote 04602260AA, 04602260AD, GQ43VT17T
Replacement Remote
Perform steps to program the remote.

1. Press the [LOCK] button 5 times on any working (programmed) transmitter at 2 second intervals to resynchronize transmitter.
2. Turn ignition to the RUN position (as far as you can go without cranking the engine). Wait for chimes to stop.
3. Using the working (programmed) transmitter, press and hold the UNLOCK button on the transmitter for between 4 and 10 seconds.
4. Within the specified 4 to 10 seconds, just keep on pressing the UNLOCK button and press the PANIC button for 1 second then release both buttons. A chime will sound to indicate that you’re now in programming mode has been entered (allow 3 seconds for chime to sound).
5. Within 30 seconds of the chime, press the LOCK and UNLOCK buttons simultaneously then press and release just the UNLOCK button on the SAME remote. A chime will sound indicating the transmitter has been re-programmed. Repeat this step (press and release the LOCK and UNLOCK buttons simultaneously then press and release just the UNLOCK button) for each new transmitter you wish to program. A chime will sound after each additional transmitter is programmed.
6. Turn the ignition OFF and remove the keys to exit the transmitter programming mode.
7. Test each transmitter for function.
Troubleshooting: If, at the “press and release just the UNLOCK button” in the second line at step 5, the
door locks unlock instead of give you a chime then you need to reverse steps 1 and 2.

Leave a Reply

Your email address will not be published. Required fields are marked *