2003 Chrysler Town & Country Key Fob Programming Instructions

This keyless remote programming instruction works on this remote with part # 04686481, 04686481AB, 04686481AC, 56049249AA, 04686481AF, and FCC id GQ43VT13T, GQ43VT17T

Replacement Remote 04686481, 04686481AB, 04686481AC, 56049249AA, 04686481AF, GQ43VT13T, GQ43VT17T
Replacement Remote
1. Press the LOCK button 5 times on any working (programmed) remote at 2 second intervals to re synchronize.
2. Turn the ignition to the RUN position (Don’t start the engine). Wait for chimes to stop.
3. Using the working (programmed) remote, press and hold the UNLOCK button on for between 4 and 10 seconds.
4. Within the specified 4 to 10 seconds, just keep on pressing the UNLOCK button and press the PANIC button for 1 second then release both buttons. A chime will sound to indicate that you’re now in programming mode has been entered (allow 3 seconds for chime to sound).
5. Within 30 seconds of chime, press the LOCK and UNLOCK buttons at the same time then press and release just the UNLOCK button on the SAME remote. A chime will sound indicating the remote has been re-programmed. Repeat this step (press and release the LOCK and UNLOCK buttons at the same time then press and release just the UNLOCK button) for each new transmitter you wish to program. A chime will sound after each additional remote is programmed.
6. Turn the ignition to OFF position and remove the keys to exit from programming mode.
7. Test each remotes function to make sure.

Troubleshooting: If, at the “press and release just the UNLOCK button” in the second line at step 5, the door locks unlock instead of giving you a chime then you need to reverse steps 1 and 2.

Leave a Reply

Your email address will not be published. Required fields are marked *