2003 Chevrolet Venture Key Fob Programming Instructions

This keyless remote programming instructions work for 4B L,U,PSD,P remote with part # 10335586, 10335582-88, OR 9364556-4575, FCC id L2C0007T on the back of it.

Replacement Remote 10335586, 10335582-88, 9364556-4575, L2C0007T
Replacement Remote
NOTE: When your system has successfully programmed a new remote, it will automatically delete all existing remote’s codes from it’s memory. Just reprogram them by following step 7.

1. Make sure your key is not in the ignition.
2. Remove the “BCM PRGRM” fuse from the fuse panel, you’ll find it by opening the front passenger door. Use the legend on the fuse panel to look for the “BCMPRGRM” fuse.

3. Close all the doors of the vehicle then close the lifgate.
4. Put the key in the ignition and turn to ACC (Do not start the engine).
5. Turn the ignition OFF and back to ACC. (Fast)
6. Open and close any door. You’ll hear a chime when the system enters programming mode.
7. Press and hold LOCK and UNLOCK buttons on your remote at the same time for 14 seconds. After 7 seconds, you’ll hear a chime which indicates the remote has been successfully programmed. Then wait approximately 14 seconds for another chime.
8. Repeat step 8 to program another remote.
9. Take the key off from the ignition.
10. Put the “BCM PRGRM” fuse back.

Leave a Reply

Your email address will not be published. Required fields are marked *