2002 Oldsmobile Intrigue Key Fob Programming Instructions

This keyless remote programming instructions work for 4B L,U,T,P remote with part # 10335582 cars, 10335588 aztek, 10335582-88, 9364556-4575 and FCC id L2C0007T on the back of it.

Replacement Remote 10335582, 10335588, 10335582-88, 9364556-4575, L2C0007T
Replacement Remote
Pease Note: Once you’ve programmed a new remote all of the existing ones saved in the system will be erased from the system’s memory. Make sure to reprogram them as well after the new one.

1. Close all car doors.
2. Put the key in the ignition and twist it to ON. (Make sure the engine did not start)
3. Turn the key ignition back to OFF and remove it.
4. Press and hold the door lock switch in the UNLOCK position until step 6.
5. Put the key in the ignition and remove it 3 TIMES then leave the key in the ignition lock cylinder on the 3rd time.
6. Release the door lock switch. Then you’ll hear three beeps which means Programming Mode has been activated.
7. Press and hold LOCK and UNLOCK buttons at the same time on the remote until the vehicle beeps twice to verify that the remote has been successfully programmed (this can take approximately 15 seconds).
8. Repeat step 7 to add more or reprogram your existing remotes (a maximum of 4).
11. Remove the key to exit Programming Mode.

Leave a Reply

Your email address will not be published. Required fields are marked *