2000 Pontiac Grand AM Key Fob Programming Instructions

This keyless remote programming instructions work for used to be 2070, 2220, 2221, 2230, 2231, 2240 remote with part # 15732805, 25656444, 25656445, 25665574, 25665575, 25628814, 25668603, 25678792, FCC id KOBUT1BT and part # D board on the back of it.

Replacement Remote 15732805, 25656444, 25656445, 25665574, 25665575, 25628814, 25668603, 25678792, KOBUT1BT
Replacement Remote
NOTE: Once you’ve programmed a new remote all of the existing ones saved in the system will be erased from the system’s memory. Make sure to reprogram them as well after the new one.

1. Close the vehicle doors.
2. Insert key in ignition and turn to ON (As far as you can without cranking engine)
3. Turn ignition OFF and remove the key from the ignition.
4. Press and hold the driver side door lock switch in the UNLOCK position and don’t let go until step 6.
5. Put the key in the ignition and remove it 3 TIMES then leave the key in the ignition lock cylinder on the 3rd time.
6. Release the door lock switch. Then you’ll hear three beeps which means Programming Mode has been activated.
7. Press and hold LOCK and UNLOCK buttons at the same time on the remote until the vehicle beeps twice to verify that the remote has been successfully programmed (this can take approximately 15 seconds).
8. Repeat step 7 to add more or reprogram your existing remotes (a maximum of 4).
9. Remove the key to exit Programming Mode.

Leave a Reply

Your email address will not be published. Required fields are marked *