2000 Nissan Maxima Key Fob Programming Instructions

This keyless remote programming instruction works on this 4B remote with FCC id # NHVWBU43

Replacement Remote NHVWBU43
Replacement Remote

NOTE: Once you placed your receiver on programming mode it’s memory will reset. So, make sure to reprogram your existing remote if you are to use them as well.
1. Close and lock all doors with the driver’s side power lock/unlock switch.

2. Put the key in the ignition and remove the key six times within 10 seconds. Your Hazard Lamps will flash if you do this step successfully. System will not enter programming mode if you do this step too fast or too slow.
3. Put key into the ignition cylinder and turn to the ACC position.
4. Within 5 seconds, press ANY button on the remote ONCE. Then your Hazard Lamps will flash. Indicating the remote and system is paired.

5. If you want to program another remote, just unlock and lock all doors using the driver’s side power lock/unlock switch and within 5 seconds, push ANY button on the remote. Your Hazard Lamps should flash. Repeat this step for each you will be programming.
6. Turn your key to the OFF position, remove it from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door.

Leave a Reply

Your email address will not be published. Required fields are marked *