1999 Volkswagen Passat Key Fob Programming Instructions

This keyless remote programming instructions work for L,U,T ROUND & P remote with part # HLO 1J0-959-753-F and FCC id NBG8137T on the back of it.

Replacement Remote
Programming Remote Steps:

1. Put the key in ignition and twist it to ON position as far as without starting the engine.
2. Leave the key in the ignition then step out of the car and close all doors including trunk and hood.

3. Lock vehicle at driver’s door with the key remote to be programmed.
4. Press any button on the new remote, release button and wait 2 seconds. Press the same button again and release.
5. The horn will beep to confirm.
6. Unlock door, remove key from ignition, and lock all doors manually with the key.

Leave a Reply

Your email address will not be published. Required fields are marked *