1999 Toyota Sienna Key Fob Programming Instructions

This keyless remote programming instructions work for GREY REMOTE remote with part # PT398-07101, 08191-00871, FCC id BAB237131-056, BAB237131-022 on the back of it.

Replacement Remote PT398-07101, 08191-00871, BAB237131-056, BAB237131-022
Replacement Remote

1. Turn the ignition ON using your key but don’t start the engine.
2. Look for the Valet button/switch then press and hold it for 3 seconds. (see figure). Use a pencil or any object to poke through the Programming Button access hole.

3. The STATUS MONITOR LED (on dash or center console) turns on for 5 seconds. For some vehicles, a double chirp of the horn is heard instead of the flashing light.
4. Within 5 seconds of lighting the status MONITOR LED, press and release the transmitter’s TOP or BOTTOM button (either button on your REMOTE CONTROL can be programmed to operate the system – the other button can be programmed to operate a second Toyota vehicle with the same system).
5. STATUS MONITOR LED will turn off, you’ll get a chirp then the exterior lights flash once. In some cases, the only response is a single horn chirp.
6. To program another remote just repeat step 2 to 4.
7. Turn OFF the ignition using your key to exit from programming mode.

Leave a Reply

Your email address will not be published. Required fields are marked *