1999 Oldsmobile Silhouette Key Fob Programming Instructions

This keyless remote programming instructions work for l,u,psd remote with part # 10245951, FCC id ABO0204T on the back of it.

Replacement Remote 10245951, ABO0204T
Replacement Remote
NOTE: When your system has successfully programmed a new remote, it will automatically delete all existing remote’s codes from it’s memory. Just reprogram them by following step 7.

1. Make sure your key is not in the ignition.
2. Remove the “BCM PRGRM” fuse from the fuse panel, you’ll find it by opening the front passenger door. Use the legend on the fuse panel to look for the “BCMPRGRM” fuse.

3. Close all of the doors.
4. Close the liftgate.
5. Insert keys into the ignition, and turn the ignition lock cylinder to ACC (one click towards you – the opposite direction from starting the engine).
6. Turn the ignition to OFF, and then quickly back to ACC.
7. Open and close any door. You’ll hear a chime when the system enters programming mode.
8. Press and hold the LOCK and UNLOCK buttons on the remote at the same time for 14 seconds. IMPORTANT: After 7 seconds, you’ll hear a chimme which indicates the remote has been successfully programmed. Then wait approximately 14 seconds for another chime. Your new remote has been programmed but all existing remote codes have been erased.
9. Repeat the previous step on each additional transmitter to be programmed  (including any existing transmitters).
10. Remove the ignition key from the ignition lock cylinder.
11. Install the “BCM PRGRM” fuse back into the fuse panel.

Leave a Reply

Your email address will not be published. Required fields are marked *