1999 Isuzu Amigo Key Fob Programming Instructions

This keyless remote programming instructions work for  remote with part # 8-97149-392-0, FCC id HYQ1512R on the back of it.

Replacement Remote 8-97149-392-0,  HYQ1512R
Replacement Remote
Here how you program your new remote to the system:
1. Driver’s door open.
2. Put the key in the ignition (don’t turn it).
3. Within 5 seconds, turn the key in the ignition to ACC position and then to LOCK position three times within 3 seconds.
4. In 10 seconds close and open the driver door twice.
5. Turn the key in the ignition to ACC and then to LOCK 3 times within 3 seconds.
6. In 10 seconds close then open the door again. This time your system will enter the programming mode and it cycles (lock then unlock) the door locks as it’s indication.
7. In 15 seconds press LOCK button on the remote. Door locks will cycle which means the remote has been successfully programmed.
8. In 15 seconds press UNLOCK button on the remote. The door locks will cycle again.
9. Start from the top to program another remote.
10. To turn the programming mode off just remove the key from the ignition.

Leave a Reply

Your email address will not be published. Required fields are marked *