1999 Chevrolet Venture Key Fob Programming Instructions

This keyless remote programming instructions work for l,u,p,psd remote with part # 10245953, FCC id ABO0204T on the back of it.

Replacement Remote 10245953, ABO0204T
Replacement Remote
1. No key in the ignition.
2. Take off the “BCM PRGRM” fuse from the fuse panel, you can find it by opening the front passenger door. Use the legend on the fuse panel to look for the “BCMPRGRM” fuse properly.
3. Close all of the doors.
4. Close the liftgate.
5. Insert keys into the ignition, and turn the ignition lock cylinder to ACC (one click towards you – the opposite direction from starting the engine).
6. Turn the ignition lock cylinder to OFF, and then back to ACC within 1 second.
7. Open and close any vehicle door. A chime will be heard when the system enters the programming mode.
8. Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 seconds. IMPORTANT: After 7 seconds, a chime may be heard confirming successful synchronization. It is necessary to wait approximately 14 seconds for a second chime that will confirm successful programming. Your new remote has
been accepted and all existing remote codes have been erased.
9. Repeat the previous step on each additional transmitter to be programmed (including any existing transmitters).
10. Remove the ignition key from the ignition lock cylinder.
11. Install the “BCM PRGRM” fuse back into the fuse panel.

Leave a Reply

Your email address will not be published. Required fields are marked *