This keyless remote programming instructions work for 3B remote with part # 16245103trunk 16245105rear2x 16245100-29 16207901-5 FCC id AB01502T and part # on the back of it.
NOTE: Once your a new remote has been programmed old remotes saved in the system’s memory will be erased. So, make sure to reprogram them after the new one.
1. Ignition OFF.
2. Look for the programming connector in the drivers side trunk. It is a plastic connector with 2 wires leading to it and not plugged to anything.
3. This connector has 2 terminals. Use a jumper wire to connect both terminals. Door locks will cycle (lock and unlock) which means your system has entered programming mode. Do not remove the jumper wire until step 6.
4. Press and hold LOCK and UNLOCK buttons on the remote for 30 seconds at the same time. The door locks will cycle to confirm the remote has been programmed.
5. Repeat the previous step for every remote (including old ones).