1997 Pontiac Sunfire Key Fob Programming Instructions

This keyless remote programming instructions work for 3B remote with part # 16245103, trunk 16245105, rear2x 16245100-29, 16207901-5, FCC id AB01502T on the back of it.

Replacement Remote 16245103, 16245105, 16245100-29, 16207901-5, AB01502T
Replacement Remote
1. Make sure the ignition is in the OFF position.
2. Locate the programming connector in the drivers side trunk. It is a plastic connector with 2 wires leading to it. It is not plugged into anything.
3. The programming connector has two terminals. Connect the terminals with a suitable jumper wire. The locks will cycle to confirm programming mode. Keep the jumper wire connected.
4. Press the LOCK and UNLOCK buttons on the remote simultaneously (for up to 30 seconds.) The door locks will cycle to confirm the remote has been learned. Release the buttons. Your new remote has been programmed and all previous remotes have been erased.
5. Repeat the previous step for every remote (including old ones).
6. Remove jumper wire.

Leave a Reply

Your email address will not be published. Required fields are marked *