1996 Toyota Paseo Key Fob Programming Instructions

This keyless remote programming instructions work for BLACK REMOTE remote with part # PT398-07100, 08191-00870, FCC id BAB237131-022 on the back of it.

Replacement Remote PT398-07100, 08191-00870, BAB237131-022
Replacement Remote
Below are the steps to program the remote to the system.

1. Put the key in the ignition and twist it to ON without starting the engine.
2. Press and hold the valet button/switch for 3 seconds (see figure). Use a pencil or any narrow object to poke through the Programming Button access hole.

3. The STATUS MONITOR LED (on dash or center console) turns on for 5 seconds. For some vehicles, a double chirp of the horn is heard instead of the flashing light.
4. Within 5 seconds of lighting the status MONITOR LED, press and release the transmitter’s TOP or BOTTOM button (either button on your REMOTE CONTROL can be programmed to operate the system – the other button can be programmed to operate a second Toyota vehicle with the same system).
5. STATUS MONITOR LED turns off, you’ll get a chirp and the exterior lights flash once. In some cases, the only response is a single horn chirp.
6. Repeat step 2 to 4 to program another remote.
7. To exit programming mode turn the key in the ignition to OFF.

1 thought on “1996 Toyota Paseo Key Fob Programming Instructions”

  1. My Toyota Paseo 1996 does not have a programming switch/button and the receiver does not looks like image above. The remote control has only one button.

Leave a Reply

Your email address will not be published. Required fields are marked *