1996 Nissan Sentra Key Fob Programming Instructions

This keyless remote programming instruction works on this remote with part # 28268-2Z021, 28268-0Z021, 1F5Z-15K601-AA and FCC id KOBUTA3T

Replacement Remote 28268-2Z021, 28268-0Z021, 1F5Z-15K601-AA, KOBUTA3T
Replacement Remote

REMINDER: Once you placed your receiver on programming mode it’s memory will be erased.So, make sure to reprogram your existing remote too if you are to use them.
1. Close and lock all doors with the driver’s side lock/unlockswitch.

2. Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your Hazard Lamps will flash if you have performed this step successfully. NOTE: Withdraw key completely from ignition cylinder each time. If this procedure is performed too fast, system will not enter programming mode.
3. Insert key into the ignition cylinder and turn to the ACC position.
4. Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should flash. NOTE: Do not press the button more than one time in the above step. If the button is pressed more than one time, the programming procedure will not be successful.

5. If you want to program another remote, just unlock and lock all doors using the driver’s side power lock/unlock switch and within 5 seconds, push ANY button on the remote. Your Hazard Lamps should flash. Repeat this step for each you will be programming.
6. Turn your key to the OFF position, remove it from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door.

1. Check the key sensor in the ignition cylinder if working by opening the driver door and inserting the key into the ignition. The chime will sound if the sensor is working properly. If the chime does not sound then you need to wiggle the key in the cylinder to see if you can place it in a position where the chime does sound. If it worked, then that’s the position you must put the key in when you insert and withdraw 6 times within 10 seconds.If you can’t wiggle into a position where it works then you need to have the sensor replaced before continuing.
2. Make sure the 6 times within 10 seconds requirement is met. The most common problem is doing this step too fast or too slow.
3. If the hazard lights flash with the key sequence but not when the remote button is pressed make sure you are meeting the 5 second timing requirement and that you are pressing the remote button only once for 1 second.
4. You can try the procedure with the seat belt on/off and windows are closed.

Leave a Reply

Your email address will not be published. Required fields are marked *