1996 Mitsubishi Montero Key Fob Programming Instructions

This keyless remote programming instructions work for L,U remote with part #  FCC id GQ43VT7T, GQ43VT4T, and part # TRW 3165189 on the back of it.

Replacement Remote GQ43VT7T, GQ43VT4T, 3165189
Replacement Remote
Follow all steps to program the remote to the system.

1. Locate the Program Connector near the keyless entry module using the reference chart below for the appropriate location. The Program Connector is a white plastic connector with two terminals that is NOT plugged into anything.
2. Jumper the two program connector terminals with a suitable jumper wire. The system will respond by locking and then unlocking all doors or chirping the horn.
3. Press the LOCK button on the first transmitter. All doors will lock and then unlock, or the horn will chirp, to verify transmitter signal acceptance.
4. Repeat step 3 for the second transmitter (if any).
5. Remove the jumper wire from the connector.

Leave a Reply

Your email address will not be published. Required fields are marked *