1996 Mitsubishi Diamante Key Fob Programming Instructions

This keyless remote programming instructions work for L,U,P remote with FCC id GQ43VT7T and GQ43VT4T on the back of it.

Replacement Remote GQ43VT7T GQ43VT4T
Replacement Remote
Perform the steps below to program/reprogram your new and old remote.

1. Look for the Program Connector near the system/receiver. The Connector is a white plastic connector with two terminals that are unplugged.
2. Use a jumper wire to connect the two program connector terminals. Door locks should cycle (lock then unlock) or you’ll hear a chirp. This means your system is no in programming mode.

3. Press the LOCK button on the first transmitter. All doors will lock and then unlock, or the horn will chirp, to verify transmitter signal acceptance.
4. Repeat step 3 for the second transmitter (if any).
5. Remove the jumper wire from the connector.

Leave a Reply

Your email address will not be published. Required fields are marked *