1996 Isuzu Trooper Key Fob Programming Instructions

This keyless remote programming instructions work for isuzu remote with FCC id BAB237131-013 on the back of it.

Replacement Remote BAB237131-013
Replacement Remote
Perform steps below to program the remote:

1. Look for the Security System Control Unit on the floor under neat the seat. You may need to move the Driver’s seat forward.
2. Put the key in the ignition and turn it to ON position.

3. Press and hold the green programming button on the control unit using any pen or pencil point. Poke through the hole about the diameter of a pen on the side of the unit. Once the LED light on the instrument panel turns on release the programming button. (make sure steps 3 and 4 are done within 5 seconds each).
4. Press the top button on the remote. LED should turn off and siren chirps once and front lights flashes which means remote has been successfully programmed.
5. Repeat steps 3 and 4 to program another remote.
6. Turn the key in the ignition to OFF position and the system will exit from programming mode.

Leave a Reply

Your email address will not be published. Required fields are marked *