1996 Isuzu Rodeo Key Fob Programming Instructions

This keyless remote programming instructions work for isuzu remote with FCC id BAB237131-013, on the back of it.

Replacement Remote BAB237131-013
Replacement Remote
1. Move the driver’s seat forward and locate the security system control unit mounted on the floor underneath the seat.
2. Turn the ignition switch to ON.
3. Press and hold the green programming button on the side of the control unit with a pencil point. You will be poking through a hole about the diameter of a pencil on the side of the unit. When the
system security system LED on the instrument panel comes on, release the programming button. (steps 3 and 4 must be done within 5 seconds of each other.)
4. Press and release the top button of the remote. Check that the LED goes out, the siren chirps once, and the front marker lights flash to confirm.
5. If you have other remotes then repeat steps 3 and 4.
6. Turn the ignition to OFF to exit programming mode.

Leave a Reply

Your email address will not be published. Required fields are marked *