This keyless remote programming instructions work for isuzu remote with FCC id BAB237131-013 on the back of it
![]() |
Replacement Remote |
1. Move the driver’s seat forward and locate the security system control unit mounted on the floor underneath the seat.
2. Turn the ignition switch to ON.
2. Turn the ignition switch to ON.
3. Press and hold the green programming button on the control unit using any pen or pencil point. Poke through the hole about the diameter of a pen on the side of the unit. Once the LED light on the instrument panel turns on release the programming button. (make sure steps 3 and 4 are done within 5 seconds each).
4. Press the top button on the remote. LED should turn off and siren chirps once and front lights flashes which means remote has been successfully programmed.
4. Press the top button on the remote. LED should turn off and siren chirps once and front lights flashes which means remote has been successfully programmed.
5. If you have other remotes then repeat steps 3 and 4.
6. Turn the ignition to OFF to exit programming mode.
6. Turn the ignition to OFF to exit programming mode.