1995 Oldsmobile Aurora Key Fob Programming Instructions

This keyless remote programming instructions work for  remote with part # 25602667, 25602668, 25602669 FCC id ABO0303T, ABO0302T on the back of it.

Replacement Remote 25602667, 25602668, 25602669, ABO0303T, ABO0302T
Replacement Remote
When your system is programming a new remote it will automatically disable/delete the existing ones so make sure to reprogram them as well if you wish to use multiple remotes for your car.

1. Insert your key in the ignition and don’t turn it.
2. Look for the Data Line Connector (DLC) underneath the driver’s side dasboard. Check the figures below (they usually aren’t numbered) based on how your DLC is positioned. Notice how the DLC is tapered on both ends: We will be working on the wider row of cavities (1 through 8 in the figure below).
3. Check if there are metal contact pins in terminals 8 and 4 and connect the Data Line Connector (DLC) terminal
8 to terminal 4 using a jumper wire. Door locks will cycle which means you’re now in programming mode.
4. Press and hold LOCK and UNLOCK buttons on the remote at the same time until the door locks cycle (Lock and Unlock). Then release the buttons.
5. To program another remote just go back to step 4.
6. Remove the jumper wire from the DLC (disconnect terminals 8 and 4).
7. Test the remotes.

1 thought on “1995 Oldsmobile Aurora Key Fob Programming Instructions”

  1. I forgot to put the key in the ignition and now nothing works right. No dash gauges working or door locks etc. How do I get it back to “normal”?

Leave a Reply

Your email address will not be published. Required fields are marked *