This keyless remote programming instruction works on this remote with part # 04688527, 04759136AB, 04759136, 04469341 AB, 04469341, FCC id GQ43VT5T, GQ43VT7T
![]() |
Replacement Remote |
1. Take the middle vent bezel off from the panel (see figure a). And look for the 2×3 traction control black connector. Remove connector and that’ll either be connected to the switch or the back of the bezel housing.
2. Turn ignition the ON (Don’t start the engine).
2. Turn ignition the ON (Don’t start the engine).
3. Use figure b as a map for your Traction Control Switch Connector (they usually aren’t numbered). The view in the picture is looking straight into the cavities of the connector. Please note that the plastic protrusions are on the bottom for proper orientation. Make sure there are metal contact pins in terminals 1 and 4 and connect the Traction Control Switch Connector terminal 1 to terminal 4 with a suitable jumper wire. Make sure you know which terminals are 1 and 4. The door locks will lock and unlock, to indicate the receiver is ready to receive transmitter code.