1991 Toyota Celica Key Fob Programming Instructions

This keyless remote programming instructions work for BLACK REMOTE remote with part # PT398-07100, 08191-00870, FCC id BAB237131-022 on the back of it.

Replacement Remote PT398-07100, 08191-00870, BAB237131-022
Replacement Remote
1. Insert the key into the ignition, and turn it to the ON position (as far as you can go without cranking the engine).
2. Press and hold the receiver PROGRAMMING SWITCH/BUTTON for 3 seconds (see figure). In some cases the button cannot be accessed with a finger – use a pencil or similar narrow object to poke through the Programming Button access hole. For most vehicles, the receiver is located underneath either the driver or passenger front seats. On others it is behind the driver’s dash. In the case of some Camry’s, the receiver can be accessed by gently prying out the black faceplate behind the mirror control switch. The black faceplate is approx. 5 inches wide by 3 inches tall.
3. The status monitor on the dash turns on for 5 seconds. For some vehicles, it’s a double chirp instead of the flashing light.
4. In 5 seconds press the remote TOP or BOTTOM button (either button on your REMOTE CONTROL can be
programmed to operate the system – other button can be programmed to operate a second Toyota vehicle with the same system).
5. STATUS MONITOR LED turns off, you’ll get a chirp and the exterior lights flash once. In some cases, the only response is a single horn chirp.
6. Repeat step 2 to 4 to program another remote.
7. To exit programming mode turn the key in the ignition to OFF.

Leave a Reply

Your email address will not be published. Required fields are marked *