1991 Toyota Camry Key Fob Programming Instructions

This keyless remote programming instructions work for BLACK REMOTE remote with part # PT398-07100, 08191-00870, FCC id BAB237131-022 on the back of it.

Replacement Remote PT398-07100, 08191-00870, BAB237131-022
Replacement Remote
Below are the steps to program the remote to the system.

1. Put the key in the ignition and twist it to ON without starting the engine.
2. Press and hold the valet button/switch for 3 seconds (see figure). Use a pencil or any narrow object to poke through the Programming Button access hole.

3. The status monitor on the dash turns on for 5 seconds. For some vehicles, it’s a double chirp instead of the flashing light.
4. In 5 seconds press the remote TOP or BOTTOM button (either button on your REMOTE CONTROL can be
programmed to operate the system – other button can be programmed to operate a second Toyota vehicle with the same system).
5. Status monitor turns off, chirps one time, and the exterior lights flash one time. In some cases, the only response is a single horn chirp.
6. Go back to step 2 to program more remotes.
7. Turn the ignition OFF and the system will exit programming mode.

Leave a Reply

Your email address will not be published. Required fields are marked *