1991 Cadillac Eldorado Key Fob Programming Instructions

This keyless remote programming instructions work for CADDY remote with part # 10269729, 10178734, FCC id AB00702T on the back of it.

Replacement Remote 10269729, 10178734, AB00702T
Replacement Remote
Before starting procedure have both remotes with you. Failure to use both remotes during the procedure will render the missing remote inoperative. If you are only programming one remote then program it as remote 1 and again as remote 2. The entire programming procedure must be completed within 30 seconds of
grounding VAC reprogramming connector (step 2). If the procedure is not completed then start over at step 1.

1. Turn the ignition to ON. 
2. Look in the trunk beneath the rear shelf between where the speakers are mounted. Ground the green single wire VAC connector located at the keyless entry receiver module (see diagram).
3. Wait for door locks to lock and unlock by themselves indicating you have entered programming mode.
4. Press UNLOCK on remote 1 twice (pause one second between presses.
5. Wait for door locks to lock and unlock by themselves.
6. Repeat step 4 and 5 for remote 2.
7. Remove ground wire from green connector.

Leave a Reply

Your email address will not be published. Required fields are marked *